HBM is announcing the dates for its "Fundamentals of strain gauge installation on plastics / fibre reinforced composites' training course, which takes place on the 18-20 May 2015.
This three-day seminar provides both practical and theoretical advice and covers a variety of topics, beginning with an introduction to the fundamentals of strain gauges (SGs), which looks at the fundamental relations between strain, mechanical stress and electrical resistance and the characteristics of SG installations on plastics.
The course also includes other essential training on strain gauge installation with both hot and cold curing adhesive; connections of strain gauges for measurements; installations of SGs in composites and plastic casts; installation planning; calibration of measurement chains; and determination of strains with unknown principal direction.
Suitable for all personnel who would like to learn how to install strain gauges on plastic and fibre-reinforced composites, no prior knowledge is required to participate in the course.
Located at the Woodland Grange Conference Centre, Warwickshire and presented by Dr Henrik Brutlach, the course will enable attendees to distinguish the differences between strain gauge installations on fibre-reinforced plastics from standard installations, through a mix of sound knowledge and practical guidance.
HBM has been a leader in Strain Gauges for over 60 years. Its extensive range allows for an exceptionally wide range of differing strain measurement applications, from experimental stress analysis, durability testing through to transducer manufacturing. Additionally, HBM provides all the necessary accessories and components for the installation of Strain Gauges, for maximum convenience.
To register or for further information on this training course, email [email protected] or visit the HBM website at www.hbm.com/en/menu/seminars/seminar-calendar.
Millbrook Proving Ground
Station Lane
MK45 2RA
UNITED KINGDOM
+44 (0)1525 304980