New panel feed-throughs for Han PushPull Profinet connectors

HARTING Ltdvisit website


New panel feed-throughs for Han PushPull Profinet connectorsHarting is launching new panel feed-throughs with transmission rates of up to 1/10Gbit/s for use with its Han PushPull Profinet connectors.

The Han PushPull (variant 14 according to IEC 61076-3-117) is the standardised connector for industrial Profinet cabling with IP65/IP67 protection. There are now two new panel feed-throughs available with robust metal housings for transmission rates up to 1/10Gbit/s Ethernet, Category 6, Class EA.

Harting says the panel feed-throughs for round and rectangular cut-outs allow swift and simple installation in devices and switch cabinets, as well as retrofitting of existing housings with a Profinet interface with IP65/IP67 protection.

The female inserts feature 360-degree shielding to increase the electromagnetic compatibility and the transmission path's immunity to interference.

Grounding options

In order that users may make independent decisions on the system's grounding concept, the RJ45 female inserts snap into the metal panel feed-throughs to provide electrical isolation. This ensures that the RJ45 shielding potential and the housing ground are not accidentally connected.

For selective grounding of the RJ45 shielding potential, the shielding potential on the panel feed-through and that on the RJ45 jack module can be gripped via a Faston connector and electrically connected to one another. Electromagnetic disturbances that are injected on the data shield and enter the device are, therefore, effectively dissipated.

Panel feed-throughs with two RJ Industrial 10G Category 6 bulkhead RJ45 jack modules and Ha-VIS preLink RJ45 cable jack are available. The RJ Industrial 10G Category 6 bulkhead RJ45 jack module offers an RJ45 interface on the device's internal IP20 side and facilitates further distribution with standard patch cables. The Ha-VIS preLink RJ45 cable jack offers simple and swift assembly with insulation displacement termination for the connection of data cables - even pre-assembled ones - with conductor cross-sections from AWG 22/7 to AWG 23/1.

Follow the link to download a PDF data sheet for the new Han PushPull feed-throughs (128kB).

© Copyright 2006-14 The Engineering Network Ltd.