Mouser Electronics is now shipping the 4-Channel, 24GHz ADF5904 receiver downconverter and the related evaluation board and controller board from Analog Devices. Available in a compact 32-lead, 5mm × 5mm LFCSP package, the ADF5904 receiver downconverter is suitable for automotive radars, industrial radars, and microwave radar sensors.
Each of the four identical channels on the Analog Devices ADF5904 contains a single-ended RF input with an on-chip balun followed by a differential low noise amplifier (LNA) and a downconverter mixer with differential output buffers. The module provides a receiver (Rx) channel gain of 22dB, 10dB noise figure, −8dBm to +5dBm LO input range, 30dB Rx to IF isolation, and 250MHz RF signal bandwidth. A simple three-wire interface controls the on-chip registers.
The EV-ADF5904SD2Z evaluation board includes the ADF5904 module, five high-frequency SMA connectors for the local oscillator input, four receiver inputs, eight SMA connectors for the baseband outputs, banana connectors for power supply, and a connector for serial interface. The kit also contains Windows-compatible software that allows designers to program the ADF5904 module. The evaluation board requires an Analog Devices EVAL-SDP-CS1Z controller board, also available from Mouser Electronics, to program the ADF5904 module. This SDP-S board provides a USB 2.0 high speed connection to the computer, allowing designers work with the EV-ADF5904SD2Z software. The SDP-S board is based on a USB-to-serial engine, which has SPI, I2C, and GPIO lines available, with a 120-pin small footprint connector.
To learn more about the ADF5904 Receiver Downconverter, visit www.mouser.com/new/Analog-Devices/adi-adf5904, and for information about the EV-ADF5904SD2Z Evaluation Board, go to www.mouser.com/new/Analog-Devices/adi-ev-adf5904sd2z.
Artisan Building, Suite C, First Floor
Hillbottom Road
HP12 4HJ
UNITED KINGDOM
+ 44 (0)1494 467490