Bürkert releases new flowmeters for high-volume gases

The main issue with measuring the flow of gas is that the accuracy can be reduced by changes in temperature and pressure. By using the calorimetric principle of flow measurement, the accuracy of these new flowmeters can be assured since it is unaffected by changes in temperature and pressure.

Both of the new products use this method of measurement which requires no moving parts, thereby not only increasing the overall reliability, but also providing relatively high accuracy at low flow rates. Both meters provide a 4-20mA analogue output signal which can be used to control a huge range of components such as process control valves and solenoid valves either directly or via a PLC.

Type 8008 is designed for pipe sizes up to 2" and can used to monitor air supplies as well as for measuring other gases. The flowmeter has an integral display which can be configured to display the measured flow in a variety of units as well as maintaining a value for the total volume measured. As standard, the maximum flow is 825Nm3/h, with special flow ranges available on request, while the maximum operating pressure is 16 bar.

The Type 8007 flowmeter can be used in pipe diameters ranging from 1/2" up to 12" (DN300) and it features a depth scale that ensures that the sensor is correctly positioned within the pipe. Available in three versions: Basic, Extended and Maximum, each calibrated for a velocity range, 85.2m/s, 170.1m/s and 206m/s, respectively. The capacity of this product type ranges from 41Nm3/h for 1/2" pipe up to 44,030Nm3/h for a Maximum version installed in a 12" pipe, with a maximum operating pressure of 50 bar.

Clearly, to ensure the accuracy levels specified, it is essential that the flowmeter is correctly installed and that it is located in an undisturbed gas stream. This is determined by the design of the pipework both upstream and downstream of the sensor location; precise details can be found in the product datasheets, which can be downloaded from the Brkert website.

More information on calibrations for non-standard gases and specific application requirements can be obtained by contacting the Brkert Technical Support department by emailing [email protected] or by visiting www.burkert.co.uk.