MachineBuilding
px

‘Kwik-Snap’ terminal blocks can reduce on-site installation time

Hylec-APL Ltdvisit website

 

Hylec-APL is launching a new range of ‘Kwik-Snap’ terminal strips which can be reduced down to the required size in seconds, reducing installation time and improving safety.

When installing electrical systems onsite, two hands are often not quite enough. If you are up a ladder, trying to hold a wire in place, with a screwdriver at the ready, then trying to cut the required number of poles from a strip of terminal blocks with a sharp Stanley knife is ill advised.

Most common terminal block strips are manufactured using polyamide, which is a strong nylon that provides a suitable and secure bed to form a connection. However it is so strong that to cut a strip down to length a sharp blade is required along with a sturdy surface to push against; this can prove troublesome and time consuming when on-site.

As a solution some manufacturers offer terminal blocks which are constructed from polyethylene, which is a far more flexible material, meaning that the strips can be easily separated by hand. While these terminal blocks may prove to be time saving during installation, they can pose a very real safety hazard. Polyethylene has a low melting point, and arcing from the connection has been suspected of causing fires.

Fortunately for electrical installers, Hylec-APL has developed a new ‘Kwik-Snap’ polypropylene terminal block which combines the toughness of one and the time saving benefits of the other. The polypropylene construction eliminates the risk of fire associated polyethylene, and allows the terminal block to be securely fastened to a panel with a screw without distorting the product. The space dividers have been designed to be easily separated by a simple twist of the hand; something that is not possible with polyamide products.

The VDE-approved ‘Kwik-Snap’ terminal block is available exclusively from Hylec-APL. It uses plated metal inserts and zinc-plated steel screws to make a secure connection. Products are available in 12 pole strips with wiring capacity from 4mm squared to 16mm squared. It is suitable for use in ambient temperatures up to 85degC, and the pole dividers have a screw hole to quickly secure the connection to most surfaces.

To find out more about the new range of ‘Kwik-Snap’ terminal strips, visit the Hylec-APL website at www.hylec-apl.com.

 
© Copyright 2006-14 The Engineering Network Ltd.